武具庫（Works）

～Where we paid most attention～

• 【Blade body markings】
  We made the base glow brightly with a bright yellow, and gradually changed it to a red near the edge to add an effect that it is not glowing fully.
• 【Jewelry and Guard】
  We paid most attention to the symmetry of the parts.
• 【The jewel with the bird's foot(?)】
  Until now we made two hemisphere parts and stuck them together, but opted not to this time.

～Other arrange points～

• The blade guard and knuckle guards were smoothed out without an edge on purpose.
• Rather than the original design, we opted to use a previous 140cm model that had nice balance as a base to go off of.
• We first designed the blade, guard and grip before making the knuckle guard as to ensure best balance. We did the same with the bird's foot

☆Laser etched plate for a wall

Nothing was mentioned about the design of this, but we thought of 3 or so ideas and suggested them to the customer.
If we get a chance, we would like to also make the designs that didn't make the final cut.